Control cabinets
Write cable outer diameter, panel-hole diameter and sheet thickness. Indoor dry air is not the same medium as an outdoor enclosure.
rubber grommet for wires purchase requirements
Translate a project into a rubber grommet for wires requirement. This page does not promise IP ratings, vibration life or a finished harness. The buyer still chooses cable outer diameter, panel thickness and the medium.
Application contexts that change the request
Automotive harness
Body-panel pass-throughs need compound, Shore A and a temperature in °F or °C with oil, fuel splash or cabin air named. IATF plant files do not replace the part page.
Appliance chassis
Power-cord and sensor wires need the insulation OD and whether the lip must sit on painted steel or bare metal.
OEM assemblies
A drawing-based rubber grommet for wires is a different request from a catalogue open ring. Keep the drawing axes on the line item.
Technical requirements before the request goes out
| Requirement | Buyer still decides | Factory confirms |
|---|---|---|
| Cable or wire outer diameter | Insulation OD in inch or mm, including jacket | Whether a standard open grommet or a split form can hold that OD |
| Panel hole and thickness | Hole diameter and sheet thickness | Lip and groove fit on that thickness |
| Service temperature | °F or °C plus the medium around the wire | Compound capability for that window, as a factory claim |
| Compound | NBR, FKM, silicone or EPDM family | Exact grade and Shore A the plant will mold |
| Documents | Which files must travel with the lot | Whether those files exist for the quoted item |
Service temperature in °F or °C has to be settled before the request goes out. Leaving it blank lets the factory pick a default that may not match the harness route. Rubber Grommets Sourcing does not fill that blank.
Silicone first versus FKM on a rubber grommet for wires
Silicone is often asked when the buyer wants a wide temperature window and, after qualification, a food-contact file. FKM is asked when the same harness sees oil, fuel splash or solvents that swell silicone. Neither compound is a default upgrade. The buyer still writes the medium; the factory only confirms a grade it can mold. Compression set and swell claims stay on the supplier page for that grade, not on this desk.
Turn the application into a written request
Keep the buyer decisions visible. This desk will not convert a photo into a promised result.
Request Factory Quotes